About Frozen Ice

The machine includes a 110 volt, single phase, 60 cycle, AC current motor with toggle switch, shaving unit, dispensing case, and separate light switch inside the case. A cutter head is mounted on the end of the motor shaft inside the shaver body (gooseneck) The pusher handle presses the ice against the revolving cutter head to product the shaved ice.
NOTE: The machine must be properly grounded to prevent electrical shock.
Tips
Start the motor and fill gooseneck an inch from the top with ice cubes or 3" x 4" pieces of ice. (The larger the ice pieces, the better the snow)
Push ice down against the cutter head with firm pressure for best snow (too much = coarse ice; too little mushy).
DO NOT force the handle.
A surface temperature of 150 degrees F. is normal.
Put only ice in the gooseneck to prevent damage to the blades.
Keep fingers away from shaver body when motor is running to prevent injury.
Unplug the machine.
Wipe all surfaces clean to avoid cleaning charges.
Cleaning Instructions


Print this page | Close Window